calipered
Fit guide

Find the gap your printer needs

Every Calipered file lists its clearances per side. This page shows how to tell, in about fifteen minutes of printing, which of those your printer handles as designed.

Drawing of the Calipered tolerance coupon: a 112 by 14 mm stepped plate with 8 holes from Ø8.10 to Ø9.00 mm, and an Ø8 mm test pin.TOP VIEWØ8.10Ø8.20Ø8.30Ø8.40Ø8.50Ø8.60Ø8.80Ø9.0014FRONT VIEW11237.2+0.6 PER STEPPINØ812
FREE-TOL-001 · tolerance coupon8 steps · pin Ø8 mm

How it works

The coupon is a stepped plate with 8 holes and a separate pin. Each step is 0.6 mm taller than the one before and its hole is a little looser, so the height of a step tells you which clearance you're testing without reading tiny numbers.

  1. Print the plate and the pin flat, as supplied, in the material you plan to use.
  2. Starting at the lowest step, push the pin into each hole without forcing it.
  3. Note the first step where the pin slides in with light friction, and the first where it spins freely.

Compare those steps with the table below and with the clearances listed in a product's README. If a design's sliding fit is 0.20 mm and your printer only slides at step 5 (0.25 mm), you know to expect a firm fit and can loosen it slightly in your slicer.

StepTop height mmHoleClearance per side
13.0Ø8.100.05
23.6Ø8.200.10
34.2Ø8.300.15
44.8Ø8.400.20
55.4Ø8.500.25
66.0Ø8.600.30
76.6Ø8.800.40
87.2Ø9.000.50

If a fit is tight

The usual cause is a squashed first layer, which slicers call elephant's foot. Most slicers have a setting to compensate for it. Turning it on often fixes fits that are tight only at the bottom.